General White Floor Tile Adhesive Glue For Large Ceramic Tiles And
PB-01 Universal Tile Glue
Applied to all kinds of ceramic tile and stone material
Strong bond ability, low stress, low dilatability,material-saving,good anti-infiltration,anti-weak acid, anti-strong alkali and anti-aging function
White, gray power
Firm, dry and clean, no grease, no wax, or other loose materials
About 24h (according to the weather)
|Initial Dry Time|
PB-01 General Tile Adhesive is a new type strong adhesive, applied
to indoor and outdoor wall paste of large-scale ceramic tile,
grassing stone, natural stone material, modifies epoxy glue with
features of strong adhesive strength, low stress, low dilatability,
no bubble, quick set, proper viscosity and easy operate, resistant
of grind, aging, cold-hot exchange.
Environmental-Friendly General Ceramic Floor Tile Adhesive For
Large Ceramic Tiles
The substrate surface should be firm, dry and clean, no grease, no
wax, or other loose materials.
1, A new type strong stone adhesive, applied to all kinds of
ceramic tile and stone material.
2, No need to wet the brick wall, effectively improve the
3, Strong bond ability, material-saving, much safer and firmer than
the traditional cement adhesive, also can reduce the construct
rubbish and the weight of the wall.
4, Good anti-infiltration and anti-aging function.
5, Can be directly used for floating rough surface, or smooth
1, The ratio:PB-01: water=3.3: 1 (20kg/bag, about 6kg water).
Stirring them into paste, using an electric mixer to make uniform
paste, put it aside for a few minutes and then a little stirring to
gain the better effect.
2, Using a tooth scraper to scrap the adhesive onto the surface
evenly, control within 1㎡, then push the ceramic tile above it.
3, For the tile or stone material with deep ditch, not only scrape
the surface, but also the backside of the tile or stone.
4, Leave 1.5mm joint space between two tiles, suggesting PB-MC
color anti-moldy gap filler.
1, Make sure the smooth and vertical rate of the surface before
2, For the ceramic tile or stone material with low
water-absorption, please use PB-03 additive or PB-05 adhesive
directly (specific refer the PB-03 and PB-05 product introduction).
3, Can not be walked on or filled crack unless finished after 24h.
4, Operating under 5℃~40℃.
5, Can be used with brick gap adhesive.
6, Never mix the dried slurry with water for second use.
7, Clean the surface by slightly wet sponge or cloth before it
coverage area differs according to the circumstance
1, adjust time: about 15min (adjust time: the effective time for
the dislocation to adjust)
1, using 3×3mm tooth scraper about 1.7kg/㎡
2, cool time: about 10min (cool time: the longest cool time that
the adhesive can last )
2, using 6×6mm tooth scraper about 3.0kg/㎡
3, initial dry time: 48h(dry solid water resistance)
4, dry time: 24h (according to the weather)
3, using 10×10mm tooth scraper about 4.5kg/㎡
5, water resistance: excellent
6, anti-weak acid, anti-strong alkali and oil resistance when dried
4, the smoother the surface, the less amount
7,non-toxic, prevent fire
8, cut degree: ＞1.2MPa (14days later), ＞1.5MPa(28days later)
Store in cool and dry place, unopened product can be saved for one