Eco Friendly High Temperature Polymer Cement Based Tile Adhesive ,
1. Strong cohesion force.
2. Be premixed and produced.
3. Strong water retention.
4. Protect the construction environment friendly.
Pinbang high-strength tile adhesive is a specific acrylic polymer-based adhesive with strengthening
bonding characteristics specifically for conventional substrates,
precast concrete panels and tile flooring.
1, Has strong cohesion force. Reduce the common phenomenon of tiles
detaching and peeling when pasted by Portland cement.
2, Be premixed and produced, the product is stable, water and used,
to protect the construction environment.
3, Has strong water retention, no need to dip tiles and wet walls,
thin construction, easy operation, to reduce material consumption
and building load.
4, Has good flexibility to resist effectively the destruction of
5, Has special formula to avoid completely the common phenomenon of
tiles cracking, detaching and peeling by Portland cement.
6, It is no-toxic, no-radiation, no smell and environmental.
7, Has special formula to prevent the flow with too much southbound
crash, easier construction.
Scope of Application:
Stickthe ceramic tile, porcelain and stone veneers on the concrete
or cement mortar plane.
Treatment of Base Plane:
1, Base plane should be smooth and firm, no dust, grease, release
agents, batik material, etc.
2, Check base plane roughness by 2m guiding rule, error should be
less than 5mm.
3, New plastering cement mortar could be constructed after 14 days
1.Construction tools: leveling instrument, dentiform drawknife (3 x
3mm,4 x4mm,6×6mm,8×8mm,10 x10mm), tile generator, motor stirrer,
big drum, cross-colloidal.
2.Stir and mix: mix tile adhesive and water as 20: (4.8-5.2) stirs
completely and waiting for 5 minutes, stir again.
3.Lay-up construction: scrape the glue paste evenly on base plane
with dentiform drawknife, the area should be about 1 m ² each time,
then knead and press on the base plane. The model of the dentiform
drawknife depends on the size of the tiles.
1, The vertical and smoothness of the substrate must be confirmed
2, The product is suitable for construction in the 5-40°C.
3, Don’t use the dried paste by reading water.
4, If the base plane is uneven or the back of tile is not smooth,
wiping the paste on the back of brick in order to ensure it full
with paste to avoid hollowing.
Use level list:
|Tile size||Drawknife size||Use level(kg/sqm)|
|10x10cm tile or mosaic or below||6x6mm toothform for base||3-4|
|60x60cm tile and stone or below||8x8mm toothform for base||4.5-6|
|60x60cm tile and stone or above||10x10mm toothform for base||6-8|
|60x60cm tile and stone or below, with deep groove|
8x8mm toothform for base
3x3mm tooth form for tile back
|60x60cm tile and stone or above, with deep groove|
10x10mm toothform for base
3x3mm tooth form for tile back
|Original tensile adhesive strength(Mpa)||≥1.0|
|Tensile adhesive strength after water(Mpa)||≥1.0|
|Tensile adhesive strength after thawing cycle(Mpa)||≥1.0|
|Tensile adhesive strength after standing for 20 min(Mpa)||≥1.0|
Keep in a cool and dry place, unopened powder valid for one year.