Outdoor Waterproofing High Temperature Tile Adhesive To Wall And
1 This product is polymer modified cement tile adhesive, and the
performance is better than general cement mortar.
2 Sliding-resistance, dispense with soaking bricks,thin
construction layers ,high stickiness,no hollowness,environment
Pinbang Cement Based Waterproofing High Temperature Tile adhesive is a grey cementitious powder containing performance
enhancing polymers and other speciality additives. This versatile,
easy-to-handle, cement-based adhesive is perfect for fixing ceramic
& vitrified wall and floor tiles, quarry tiles and similar
materials. It provides strong adhesion to cement/sand screeds, to
in-situ/pre-cast and aerated concrete, and brickwork. It is
suitable for use where the tiling is fully immersed in water.
It can be used in sticking general tile ,ceramic tile, mosaic tile
, small size natural dimension stone etc. on the concrete surface ,
plaster base surface , on brick wall in outdoor and outdoor.
1, All the surface should be strong, dry,clean, no shake, oil
stain,wax stain, concrete curing agent and other loose things.
2, If the surface is covered with paint, it should be hacked and at
least exposed 80%.
3, New concrete surface should be cured for 28 days at least. Then
4, New plaster base should be cured for 7 days at least. Then pave
5, You can use industrial detergent or degreasing dirt agent to
clean the old concrete or plaster surface. Then use high pressure
tap to clean up. It can be paved tile after airing 24h.
6, Clean the residue of concrete surface, especially the residual
mold release of the slant concrete surface.
7, Before construction, the surface need to be wetted, if the
surface is water absorption strong or in high temperature,dry
1, 6mm×6mm notched scraper is suggested, when sticking small size
2, 10mm×10mm or 12mm×12mm notched scraper is suggested, when
sticking big size tile.
3, Referent dosage of using different notched scraper
Approx. 90 minutes @ 20°C
30 minutes@ 20°C
5– 6m2/25kg bag @3mm bed
|TENSILE ADHESION STRENGTH|
≥1.5MPa under all test conditions
|EARLY TENSILE ADHESION STRENGTH|
≥1.0MPa after 6 hours
1, the temperature of construction is 5~40°C41~104F.
2, Use electric blender to stir, and stir it again after place that
can improve adhesive power.
3, The dosage of adding water, can be adjusted according to the
surface/ weather/construction condition etc.
4, During the rainy day, you should protect the construction area
doesn’t be wetted with rain within 24h.
5, According with weather condition that the glassed tile of mixing
well should be used up within 2~3h.
6, Strictly prohibit mixing dry and hard glassed tile mortar to use
7, The caulking construction should be done after tile mortar dry
and is hardened completely.( about 24h)
8, Glassed tile mortar should be plastered evenly and fully, and
the thickness of adhering layer is half as high as the notched
space of scraper.
Keep in a cool and dry place, unopened powder valid for one year.