Synthetic Flexible Mosaic Heat Resistant Tile Adhesive For Bonding
PB-05 Marble Tile Adhesive(C2)
Strong cohesion force, strong water retention, non-toxic, easier construction, good flexibility
White, gray power
Suited for bonding marble on interior and exterior wall and floor
Smooth and firm, no dust, grease, release agents, batik material,
About 24h (according to the weather)
PB-05 Marble Tile Adhesive (C2) is a new type strong adhesive, applied to indoor and outdoor wall
paste of large-scale ceramic tile, grassing stone, natural stone
material, modifies epoxy glue with features of strong adhesive
strength, low stress, low dilatability, no bubble, quick set,
proper viscosity and easy operate, resistant of grind, aging,
1, A new type strong adhesive, applied to indoor and outdoor wall
paste of large-sized ceramic tile, grassing stone and natural stone
2, Light steel frame system board, like indoor paste ceramic tile
gypsum board and Eterpan.
3, Can be used on the low water-absorption surface, like pasting
new ceramic tile above the old ones, and can be used on the firm
4, Excellent flexibility, can bear the stretch of the bonding layer
that caused by temperature difference.
5, Good anti-infiltration function.
6, No need to wet the brick wall, effectively improve the
1, The substrate surface should be firm, dry and clean, no grease,
no wax, and other loose materials.
2, For the new wall, when leveling the cement mortar, should
improve the mortar mark to strengthen the bonding power between the
leveling layer and the wall, or mix PB-03 cement mortar
additive.Specific information please refer to the PB-03
1, Using a tooth scraper to scrap the adhesive onto the surface
evenly, control within 1㎡.
2, Push the ceramic tile or heavy type ceramic tile above it
3, For the tile or stone material with deep ditch, not only scrape
the surface, but also the backside of the tile or stone.
1, Never mix the dry slurry with water for second use.
2, For the light wall pasting large-sized decorative boards, like
gypsum board and Eterpan, confirming the wall firmness before
3, For the painting surface, make sure the initial bond strength
and have no cavitation.
4, Operating in the situation under 5℃~40℃.
5, Clean the surface by slightly wet sponge or cloth before it
6, Leave 1.5mm joint space between two tiles, suggesting PB-MC
color anti-moldy gap filler.
Store in cool and dry place, unopened product can be saved for one
1, using 3×3mm tooth scraper about 1.7kg/㎡
1, adjust time: about 15min (adjust time: the
effective time for the dislocation to adjust)
2,using 6×6mm tooth scraper about 3.0kg/㎡
2, cool time: about 10min (cool time: the
longest cool time that the adhesive can last )
3, using 10×10mm tooth scraper about 4.5kg/㎡
3, dry time: 24h (according to the weather)
4, water resistance: excellent; non-toxic,
the smoother the surface, the less amount.
5, when dry, anti-weak acid, anti-strong alkali
and oil resistance
6, cut degree: ＞1.2MPa (14days later)