Water Resistant Cement Based Ceramic Floor And Wall Tile Adhesive ,
White, gray power
Strong bonding power, excellent flexibility, good anti-infiltration,anti-weak acid, anti-strong alkali and anti-oil function, easy to use, water resistant
Applied for fixing ceramic & vitrified wall and floor tiles, quarry
tiles and similar materials
Firm, dry and clean, no grease, no wax, and other loose materials
About 24h (according to the weather)
＞1.2MPa (14days later)
Pinbang Tile adhesive is a grey cementitious powder containing
performance enhancing polymers and other speciality additives. This
versatile, easy-to-handle, cement-based adhesive is perfect for
fixing ceramic & vitrified wall and floor tiles, quarry tiles
and similar materials. It provides strong adhesion to cement/sand
screeds, to in-situ/pre-cast and aerated concrete, and brickwork.
It is suitable for use where the tiling is fully immersed in water.
Cementitious, polymer modified general purpose tile adhesive.
1, Tile on tile applications.
2, New tiling in internal areas & floors inexternalCeramics,
Marble and decorative cladding.
3, Kitchens, showers & wet processing areasLaboratories,
hospitals, canteens, etc.
4, Tiling swimming pools and fountains.
5, Tiling corridors, pavements, podiums an roofs.
1, Water resistant.
2, Precision made.
3, High adhesive bond strength.
4, Easy to use.
5, Long open time.
6, Direction for use.
1, The substrate must be solid, clean and load-bearing.
2, Oil stains, bond-inhibiting surfaces and contaminations must be
3, Irregularities on walls are to be levelled. Allow primer to dry.
4, Freshly installed cement screeds must not have residual moisture
content above 5 %.
5, For tile-on-tile applications, the existing tile surface needs
to be cleaned and washed with clean water making it free from wax,
oil, grease, polish, paint and any other stains.
Concrete, screeds, renders, and block work should be cured
sufficiently to allow for most of the shrinkage movements.
Tiles must be dry, and their surfaces free of contaminants that
could impair adhesion. Do not soak tiles in water before lying.
1, Place gauging water in a clean mixing vessel.
2, Add powder and mix with a suitable stirrer or mixer mounted on
slow speed electric drill until plastic, lumps free consistency is
3, Allow to stand for 5 minutes before use .