Waterproof Bonding Ceramic Tile Adhesive , Tough Stone Adhesive For
PB-03 Tough Stone Adhesive
White, gray power
Mainly applied to bond all kinds of low water-absorption stone materials on the surfaces of wall, ground and floor
Strong bond ability, material-saving, much safer and firmer, stable performance, no-toxic, environmental, good flexibility
Firm, dry and clean, no grease, no wax, and other loose materials
about 24h(according to the weather)
PB-03 Tough Stone Adhesive is a kind of high quality
environment-friendly waterborne powder which can be mixed with
water and used for bonding ceramic tile on the surfaces of wall,
ground and floor. It is easily applied and can achieve an excellent
1, A new type strong stone adhesive, applied to all kinds of low
water-absorption stone materials like large-sized artificial
stones, culture stones, and natural stones.
2, No need to wet the brick wall, effectively improve the
3, Strong bond ability, material-saving, much safer and firmer than
the traditional cement adhesive, also can reduce the construct
trash and the weight of the wall.
4, Good anti-acid, anti-alkali, anti-infiltration and anti-aging
5, Small shrinking rate, no cracking, can be used in cold and humid
1, The adhesive for the cement plaster, brick and smooth cement
2, The adhesive for low water-absorption surface and light weight
board, like Eterpan, Pine Board and gypsum board.
The substrate surface should be firm, dry and clean, no grease, no
wax, and other loose materials.
Coverage areas differ according to the circumstance:
1, Using 3×3mm tooth scraper about 1.8kg/㎡;
2, Using 6×6mm tooth scraper about 3kg/㎡;
3, Using 10×10mm tooth scraper about 4.8kg/㎡;
Note: The amount is related to the smoothness, vertical rate, and
thickness of the stone material.
1, Make sure the smooth and vertical rate of the surface before
2, Never mix the dry slurry with water for second use.
3, Check the mortar layer of the back side, make sure that have no
4, Can not be walked on or filled crack unless finished after 24h.
1, The ratio: PB-03: water=3.3: 1 (20kg powder, about 6kg water)
.Stirring them into paste, using an electric mixer to make uniform
paste, put it aside for a few minutes and then a little stirring to
gain the better effect.
2, Using tooth scraper to scrap the adhesive onto the surface
evenly, control within 1㎡, then push the stone above it.
3, For the tile or stone material with deep ditch, not only scrape
the surface, but also the backside of the tile or stone.
Store in cool and dry place, unopened product can be saved for one