Easy to use, no pre-soaking of tiles, good workability, long open
time, excellent bond strength, excellent non-sag formula for wall
application, dual purpose for walls and floors.
1, Remove all deteriorated concrete, dirt, oil, grease and other
bond inhibiting materials from the surface. Cleaning should be done
by sandblasting, high pressure water blasting, scrabbling or other
appropriate mechanical means.
2, Substrate should be saturated surface dry and free of surplus
water prior to application.
3, New concrete slabs should be damp cured and 28 days old before
4, Newly plaster walls should be 14 days old before application.
1, Place clean, potable water into a clean container. Add pre-mixed
thinset mortar powder gradually to the measured quantity of water.
The mix ratio is depending on the type of thinset mortar.
2, Mix with a slow speed electric drill mixer until a smooth,
uniform, homogeneous mortar consistency is achieved. Allow the mix
to stand for 3~5 minutes for additive to dissolve.
3, Re-adjust consistency if necessary, re-mix for 1~2 minutes, and
apply with the proper sized notched trowel.
1, The receiving substrate should be damp, free from surplus water.
2, Apply thinset mortar to the substrate with the flat side of the
trowel, pressing firmly to work into surface. Comb on additional
thinset mortar with the notched side. Note: use the proper sized
notched trowel to ensure full bedding of the tile.
3, Spread the thinset mortar evenly over the surface and firmly
place the tiles into the wet thinset mortar before any premature
drying occurs. It is best to be done within 20 minutes. Double
spreading of the thinset mortar may be required for large format
4, Ensure complete tile bedding is achieved by intermittent
checking of placed tiles.
1, Allow 24 hours for thinset mortar set hard before applying tile
2, The wet thinset mortar should be used within the pot life
approximate 2 hours.
3, Once the thinset mortar is dried, it should be discarded and
never add water and reuse again.
Pinbang Waterproof Outdoor Tile Adhesive cannot be directly applied on wooden substrate. For further
information, please feel free to contact us.
1 year shelf life if factory packed, sealed pallets and stored off
the ground in a dry area.