Eco Friendly Outdoor Tile Adhesive / Exterior Tile Glue , Super
Pinbang Exterior Tile Adhesive Outdoor Tile Adhesive.
1, Super bonding power.
2, Strong water retention capacity.
3, Good flexiblity.
Pinbang Exterior Tile Adhesive Outdoor Tile Adhesive is a kind of high quality environment-friendly waterborne powder
which can be mixed with water and used for bonding ceramic tile on
the surfaces of wall, ground and floor. It is easily applied and
can achieve an excellent adhesion.
Where to use:
For wall surface: To bond ceramic tile (maximum is 60X60cm) on the
concrete or cement sand rendering.
For floor and ground: To bond ceramic tile or building stone.
1, Super bonding power, avoid the hollow caused by ceramic tile
which contacted with cement.
2, Stable performance, use directly after mix it with water.
3, Strong water retention capacity, no need to soak the tile or wet
the wall. Reduce the dosage of adhesive and the load on the
4, Good flexibility, resistant to all kinds of impact.
5, Nontoxic, non-radiant, no irritative odor.
6, Special anti-sagging formula, easier application.
1, The surface should be vertical, flat, smooth and free of dust,
grease and other contaminants.
2, The new cement mortar surface should be maintained at least 14
days before the application of the adhesive.
1, Mix the powder with water at the ratio of 20:4.8-5.2, and then
use electrical blender to stir evenly.
2, Keep the mixture for 5 to 10 minutes, and then stir it again to
achieve the best result.
3, Finally apply the adhesive on the surface with the notched
scraper, and then put the ceramic tile on the surface and press.
Mixing Ratio (powder: water): 20: (4.8-5.2)
electrical blender, notched scraper(3X3mm, 4X4mm, 6X6mm, 8X8mm,
10X10mm), horizontal ruler etc.