Acrylic Polymer-Based Outdoor Tile Adhesive For Porcelain Tiles ,
Pinbang high-strength outdoor tile adhesive is a specific acrylic polymer-based adhesive with strengthening
bonding characteristics specifically for conventional substrates,
precast concrete panels and tile flooring.
1, Has strong cohesion force. Reduce the common phenomenon of tiles
detaching and peeling when pasted by Portland cement.
2, Be premixed and produced, the product is stable, water and used,
to protect the construction environment.
3, Has strong water retention, no need to dip tiles and wet walls,
thin construction, easy operation, to reduce material consumption
and building load.
4, Has good flexibility to resist effectively the destruction of
5, Has special formula to avoid completely the common phenomenon of
tiles cracking, detaching and peeling by Portland cement.
6, It is no-toxic, no-radiation, no smell and environmental.
7, Has special formula to prevent the flow with too much southbound
crash, easier construction.
Scope of Application:
Stickthe ceramic tile, porcelain and stone veneers on the concrete
or cement mortar plane.
The substrate surface should be firm, dry and clean, no grease, no
wax, or other loose materials.
1. Construction tools: leveling instrument, dentiform drawknife (3
x 3mm,4 x4mm,6×6mm,8×8mm,10 x10mm), tile generator, motor stirrer,
big drum, cross-colloidal.
2. Stir and mix: mix tile adhesive and water as 20: (4.8-5.2) stirs
completely and waiting for 5 minutes, stir again.
3. Lay-up construction: scrape the glue paste evenly on base plane
with dentiform drawknife, the area should be about 1 m ² each time,
then knead and press on the base plane. The model of the dentiform
drawknife depends on the size of the tiles.
1, Make sure the smooth and vertical rate of the surface before
2, For the ceramic tile or stone material with low
water-absorption, please use PB-03 additive or PB-05 adhesive
directly (specific refer the PB-03 and PB-05 product introduction).
3, Can not be walked on or filled crack unless finished after 24h.
4, Operating under 5℃~40℃.
5, Can be used with brick gap adhesive.
6, Never mix the dried slurry with water for second use.
7, Clean the surface by slightly wet sponge or cloth before it
|Original tensile adhesive strength(Mpa)||≥1.0|
|Tensile adhesive strength after water(Mpa)||≥1.0|
|Tensile adhesive strength after thawing cycle(Mpa)||≥1.0|
|Tensile adhesive strength after standing for 20 min(Mpa)||≥1.0|
Keep in a cool and dry place, unopened powder valid for one year.