Exterior Mosaic Heat Resistant Tile Adhesive Waterproof For Bonding
PB-04 Tough Sandstone Adhesive
Applied to all kinds of low water-absorption stone materials like
large-sized artificial stones, culture stones, and natural stones
White, gray power
Strong bond ability, material-saving, much safer and firmer, good anti-acid, anti-alkali, anti-infiltration and anti-aging
Smooth and firm, no dust, grease, release agents, batik material,
|Full curing time|
PB-04 Tough Sandstone Adhesive specially for bonding sandstone on interior and exterior wall and
floor. Sandstone is low strength, not so heavy, low
water-absorption and becomes black and mildewed when meets alkali.
PB-04 is high bonding strength, low alkali and avoids the sandstone
becoming black and mildewed. Suitable for bonding sandstone on
cement mortar, concrete, Eterpan etc such strong substrates.
1, A new type strong stone adhesive, applied to all kinds of low
water-absorption stone materials like large-sized artificial
stones, culture stones, and natural stones.
2, No need to wet the brick wall, effectively improve the
3, Strong bond ability, material-saving, much safer and firmer than
the traditional cement adhesive, also can reduce the construct
trash and the weight of the wall.
4, Good anti-acid, anti-alkali, anti-infiltration and anti-aging
5, Small shrinking rate, no cracking, can be used in cold and humid
1, The adhesive for the cement plaster, brick and smooth cement
2, The adhesive for low water-absorption surface and light weight
board, like Eterpan, Pine Board and gypsum board.
The substrate surface should be firm, dry and clean, no grease, no
wax, and other loose materials.
1, The ratio: PB-04: water=3.3: 1 (20kg powder, about 6kg water).
Mixing and stirring them into paste, using an electric mixer to
make uniform paste, put it aside for a few minutes and then a
little stirring to gain the better effect.
2, Using a tooth scraper to scrap the adhesive onto the surface
evenly, control within 1㎡, then push the stone above it.
3, For the tile or stone material with deep ditch, not only scrape
the surface, but also the backside of the tile or stone.
Size of notched trowel
Adjusting time: 15 minutes
Hardening time: 10 minutes
Full curing time: 24 hours
Resistance to acids and alkali
Shearing strength >1.5MPA(14days)
Bricks for wall using 3×3mm tooth scraper or 6×6mm tooth scraper.
Bricks for floor using 6×6mm tooth scraper or 10×10mm tooth
1, Make sure the smooth and vertical rate of the surface before
2, Never mix the dry slurry with water for second use.
3, Check the mortar layer of the back side, make sure that have no
4, Can not be walked on or filled crack unless finished after 24h.
Store in cool and dry place, unopened product can be saved for one