Non-toxic White Ceramic Rapid Set Floor Tile Adhesive , Flexible
Stone Glue C2
PB-303 Flexible Stone Glue (C2)
High flexibility,strong cohesion force, easy to paste, strong water retention, thin construction, no-toxic, environment friendly
White, gray power
Bonding gravel, natural cultured stone and artificial cultured
stone on interior and exterior wall and floor
Smooth and firm, no dust, grease, release agents, batik material,
5℃ ~ 40℃
Surface Dry Time
PB-303 is a kind of high quality environment-friendly waterborne
powder which can be mixed with water and used for bonding ceramic
tile on the surfaces of wall, ground and floor. It is easily
applied and can achieve an excellent adhesion.It has strong
cohesion force. Reduce the common phenomenon of tiles detaching and
peeling when pasted by Portland cement.
1. Has strong cohesion force.
2. Be premixed and produced, easy operation
3. Has strong water retention, thin construction, to reduce
material consumption and building load.
4. Has good flexibility to resist effectively the destruction of
5. Has special formula to avoid completely the common phenomenon of
tiles cracking, detaching and peeling by Portland cement.
6. It is no-toxic, no-radiation, no smell and environmental.
7. Has special formula to prevent the flow with too much southbound
crash, easier construction.
Treatment of base plane:
1. Base plane should be smooth and firm, no dust, grease, release
agents, batik material, etc.
2. Check base plane roughness by 2m guiding rule, error should be
less than 5mm.
3. New plastering cement mortar could be constructed after 14 days
1. Construction tools:Leveling instrument, dentiform drawknife
(3×3mm,4×4mm, 6×6mm, 8×8mm, 10×10mm), tile generator, motor
stirrer, big drum, cross-colloidal.
2. Stir and mix:Mix tile adhesive and water as 20:(5~6.5) stirs
completely and waiting for 5 minutes, stir again.
3. Layup construction:Scrape the glue paste evenly on base plane
with dentiform drawknife, the area should be about 1 m ² each time,
then knead and press on the base plane.The model of the dentiform
drawknife depends on the size of the tiles.
Original tensile adhesive strength(Mpa)
Tensile adhesive strength after water(Mpa)
Tensile adhesive strength after thermal aging(Mpa)
Tensile adhesive strength after thawing cycle(Mpa)
Tensile adhesive strength after standing for 20 min(Mpa)
1. The vertical and smoothness of the substrate must be confirmed
2. The product is suitable for construction in the 5℃~40℃.
3. Don't use the dried paste by reading water.
4. If the base plane is uneven or the back of tile is not smooth,
wiping the paste on the back of brick in order to ensure it full
with paste to avoid hollowing.
Store in cool and dry place, unopened product can be saved for one