White Stone Gum Mosaic Marble Bathroom Tile Adhesive Waterproof ,
PB-03 Super Stone Gum
White, gray power
Strong bond ability, material-saving, easily applied, stable performance, no-toxic, environmental, good flexibility
Mainly applied to bond all kinds of low water-absorption stone materials on the surfaces of wall, ground and floor
Firm, dry and clean, no grease, no wax, and other loose materials
about 24h(according to the weather)
PB-03 Super Stone Gum is a kind of high quality
environment-friendly waterborne powder which can be mixed with
water and used for bonding ceramic tile on the surfaces of wall,
ground and floor. It is easily applied and can achieve an excellent
Where to use:
For wall surface: To bond ceramic tile (maximum is 60×60cm) on the
concrete or cement sand rendering.
For floor and ground:
To bond ceramic tile or building stone.
For all kinds of damp place; Swimming pool/tanks, water proof roof
and balcony, bathrooms etc.
1. Super bonding power, avoid the hollow caused by ceramic tile
which contacted with cement;
2. Stable performance, use directly after mix it with water;
3. Strong water retention capacity, no need to soak the tile or wet
the wall. Reduce the dosage of adhesive and the load on the
4. Good flexibility, resistant to all kinds of impact;
5. Nontoxic, non-radiant, no irritative odor;
6. Special anti-sagging formula, easier application.
Standard: ≥ 0.5
After freeze-thaw cycle: ≥ 0.5
After dipped into water: ≥ 0.5
After heat aging: ≥ 0.5
After airing (20 minutes): ≥ 0.5
Powder (airtight): 1 year
1. Application temperature: 5℃~40 ℃.
2. Control the mixing ratio of powder and water strictly to avoid
too thick or too Thin and damage its performance.
3. Don't add water into the dry and hard adhesive mixture and use
4. If the surface and tile's backside is not even enough, apply
some adhesive On the tile's backside to avoid hollowing.
5. Store in a cool, dry and well-ventilated place.
1. Surface Preparation:
The surface should be vertical, flat, smooth and free of dust,
grease and other Contaminants.
The new cement mortar surface should be maintained at least 14 days
before The application of the adhesive.
2. Application Method:
Mix the powder with water at the ratio of 20: (5~6.5), and then use
electrical Blender to stir evenly.
Keep the mixture for 5 to 10 minutes, and then stir it again to
achieve the best Result.
Finally apply the adhesive on the surface with the notched scraper,
and then Put the ceramic tile on the surface and press.
Mixing Ratio (powder: Water): 20: (5~6.5)
Application Tool: Electrical blender, notched scraper(3×3mm, 4×4mm,
6×6mm, 8×8mm, 10×10mm), horizontal ruler etc.
Store in cool and dry place, unopened product can be saved for one