Outdoor Ceramic / Marble Floor Tile Adhesive And Grout Grey , Eco
PB-02 Retread Tile Adhesive(C2)
White, gray power
Strong bonding power, good flexibility, material-saving,good anti-infiltration and anti-aging function, non-toxic, prevent fire,no-radiation, no smell and environmental
Firm, smooth, dry and clean, no grease, no wax, and other loose materials
Applied to indoor and outdoor wall paste of large-sized ceramic
tile, grassing stone and natural stone material
About 24h (according to the weather)
＞1.2MPa (14days later)
PB-02 Tile Adhesive is a high performance, professional formula
adhesive with the high bond strengths required for all kinds of
tiles and stones installations. Suited for ceramic, mosaic, quarry,
pavers, gauged slate, porcelain and gauged stone tile. PB-02
provides maximum resistance to intermittent water exposure.
1, Particularly strong bonding power, applied to indoor and outdoor
wall paste of large-sized ceramic tile, grassing stone and natural
2, Light steel frame system board, like indoor paste ceramic tile
gypsum board and Eterpan.
3, Can be used on the low water-absorption surface, like pasting
new ceramic tile above the old ones, and can be used on the firm
4, Excellent flexibility, can bear the stretch of the bonding layer
that caused by temperature difference.
5, Good anti-infiltration function.
6, No need to wet the brick wall, effectively improve the
1, The substrate surface should be firm, dry and clean, no grease,
no wax, and other loose materials.
2, For the new wall, when leveling the cement mortar, should
improve the mortar mark to strengthen the bonding power between the
leveling layer and the wall, or mix PB-03 cement mortar additive.
Specific information please refer to the PB-03 introduction.
1, Using a tooth scraper to scrap the adhesive onto the surface
evenly, control within 1㎡.
2, Push the ceramic tile or heavy type ceramic tile above it
3, For the tile or stone material with deep ditch, not only scrape
the surface, but also the backside of the tile or stone.
4,Can be used for the old ceramic tile retreading.
1, Never mix the dry slurry with water for second use.
2, For the light wall pasting large-sized decorative boards, like
gypsum board and Eterpan, confirming the wall firmness before
3, For the painting surface, make sure the initial bond strength
and have no cavitation.
4, Operating in the situation under 5℃~40℃.
5, Clean the surface by slightly wet sponge or cloth before it
6, Leave 1.5mm joint space between two tiles, suggesting MB-MC
color anti-moldy gap filler.
Store in cool and dry place, unopened product can be saved for one
1, using 3×3mm tooth scraper about 1.7kg/㎡
1, adjust time: about 15min (adjust time: the effective time for
the dislocation to adjust)
2,using 6×6mm tooth scraper about 3.0kg/㎡
2, cool time: about 10min (cool time: the longest cool time that
the adhesive can last )
3, using 10×10mm tooth scraper about 4.5kg/㎡
3, dry time: 24h (according to the weather)
4, water resistance: excellent; non-toxic, prevent fire
the smoother the surface, the less amount.
5, when dry, anti-weak acid, anti-strong alkali and oil resistance
6, cut degree: ＞1.2MPa (14days later)