White Cement Based Wall Putty With Interior Lacquer Putty
1, Strong bonding power, can be well attached to the wall and
2, Certain penetrating function, can close down the pores on the
surface and form a waterproof layer.
3, Good flexibility, can meet the requirement of elasticity
modulus, keep the elastic coating and the base surface from
4, Good anti-crack function, can effectively prevent the bottom
layer extending toward the surface.
5, Excellent anti-aging function and good anti-corrosion,
non-toxic, harmless and environmental friendly product.
This product is suitable for the elastic coating system with
water-proof, damp-proof and high-elasticity function and the
surface system with external-wall-insulation function.
1, The ratio: 20kg powder + 2kg additive + appropriate water; 20kg
powder + 8kg additive + appropriate water.
2, Pouring the additive into the container, and adding the powder
and appropriate water slowly, then stirring them into a uniform,
no-powder and no-deposition paste .
3, If the wall is too dry, wet the wall before operation. The
substrate surface should be firm, dry and clean, no grease, no wax,
and other loose materials. The obvious pores and holes must be
silted up with the cement mortar, the sharp edges should be wiped
4, Using trowel to scrape the slurry onto the surface, suggesting
two times, each time keep the thickness under 1mm, the total
thickness should less than 2mm.
5, The second time should scrap 6~12h after finishing the first
For the smooth surface, and the thickness of putty is 1.5~2.0mm,
1, operation: no scratching barrier
2, dry time: ≤5h
3, initial drying crack: no crack
4, surface PH: 8~10
5, water absorption: ≤ 2
6, bond strength: ≥0.6
7, the dynamic crack resistance: ≥0.3mm
1, Do not scrap again and again, finish it within one time.
2, It must be well protected against rain, sunlight and the frost
within 24 hours after finished operating.
3, The mixed skim coat should be used up within 3h. Never mix the
dry slurry with water for second use.
4, Operating in the situation under 5℃~40℃, and never operate under
Store in cool and dry place, the liquid component should be saved
in the environment above 5 ℃,
unopened product can be saved for one year.
20kg powder + 2kg additive/set
20kg powder + 8kg additive/set