Waterproof Swimming Pool Tile Grout With Two Component Epoxy
Pinbang color epoxy grout is one kind of double-component epoxy
resin product, contains silica sand and special additives.
Excellent acid resistance and clean power. It has the following
1, Excellent mechanical strength and chemical resistance, more
2, The surface is smooth after finished caulking, low
water-absorption and easy to clean.
3, Easy to use and the surface can be quickly repaired.
4, Being high load resistant after the grout dried.
5, No shrinkage and no cracking.
6, Uniform color, uvioresistant and
7, Excellent binding power.
1, Thin thickness. Pinbang color epoxy grout can also caulk the
seams less than 3mm of glass mosaic.
2, When caulking the brick corners which are too wet or polluted by
dirt and grease, Pinbang color epoxy grout does not guarantee to
3, Unglazed quarry brick should be used the same color with grout,
other kinds of color only can be used for enamel brick.
4, Pinbang color epoxy grout cannot be used on ceramic tile, for it
hard to clean.
5, Caulking the vitrified bricks that have a large color difference
with grout, must carry on a preliminary test before operation (such
as caulking the white brick with a black color).
6, Before caulking the stone or smooth vitrified brick, carries on
a preliminary test first.
7, Do not add water or solvent in order to increase the liquidity
of the grout.
8, Should be used in 12 ℃~30 ℃ temperature range .
9, Mix the product in right mixing ratio in strict accordance with
the requirements.Incorrect mixing ratio may affect the hardening of
Used as acidoresistant grout:
1)The gap must be clean, no dust, the depth of the seam should be
at least two-thirds of the thickness of the ceramic tile. Do the
clearance before the mortar dried.
2)Make sure the tile adhesive or mortar have hardened and
volatilized most of the moisture before grouting.
3) Moisture on the brick surface does not affect the grouting. The
brick seam should not be wet when grouting.
Pouring the hardener B component into the container which contains
A component, stirring them into a uniform state. Use a slow stirrer
to avoid overheating and reduce the working hours of the product.
The grout should be used up within 45 minutes after stirred.
Use a proper-size Pinbang scraper to fill the brick seam with the
grout. Blow away the needless grout with a same-tooth-surfacethe
4, Surface dressing:
1) After jointed, clear the grout on the ground and the wall
immediately before the grout dried out.
2) Wet the surface with Scotch-Brite fully, don't scour the brick
seam. The clean cushions should be fully wetted when cleaning the
surface.Wipe away the needless grout with a wet-porous-hard sponge,
which should be replaced with another if it gets filled with resin.
3) Extremely important, when finished surface dressing, it is not
allowed that Mebong Color Epoxy Grout remain on the surface of the
ceramic tile for it difficult to clean.So it is necessary to water
the sponge constantly.
Store in cool and dry place, unopened product can be saved for one