Interior / Exterior Wall Ceramic Wall Tile Adhesive Fast Setting
|Component||Portland cement, non-reactive aggregate, graded sand and other
|Max. aggregate size||1.0 mm|
|Water demand||Approx. 25-28% or 5-5.6 L/20 kg bag|
1.4 kg/L (dry)
1.4 kg/L (wet) for using 26% water demand
|Pot life||Approx. 1 hour|
Pinbang Fast Fix, fast setting, strong polymerized thin bed tile
adhesive for interior and exterior wall tile fixing complied with
C1FT class of EN 12004.
Pinbang Fast Fix is a cementitious, water resistant, and single
component tile adhesive. It is designed simply to mix with water to
give strong, non-slip, and highly workable adhesive mortar for both
interior and exterior applications with setting time of 6 hours. It
is specially designed for renovation purpose with fast setting
time. Ideal for installation of porous and vitreous tiles such as
marble, granite, ceramic, and homogenous tiles for walls and
floors. Suitable substrates are concrete, cement plasters, gypsum
boards, brickworks and ALC blockwalls.
Where to use:
1, For wall surface:To bond ceramic tile (maximum is 60×60cm) on
the concrete or cement sand rendering.
2, For floor and ground: To bond ceramic tile or building stone.
3, For all kinds of damp place: Swimming pool/tanks, water proof
roof and balcony, bathrooms etc.
1, never can be used to withstand the wall or ground severe
deformation and vibration of the plywood, particle board, asbestos
2, without adequate maintenance, unstable concrete or fabrication.
3, metal surface.
4, when using the PB-01 General Tile Adhesive, the chromatic
aberration between tint glass mosaic and surface material should be
reduced to a minimum.
1, Substrate Preparations:
Substrate must be free from grease, mould oil, rust, rusty metal,
wood peels, paints, plastics, loose particles, contamination on any
traces of foreign materials affecting the adhesion of Pinbang Fast
2, Mixing and Installation:
1) Pinbang Fast Fix can be applied at least 7 days after the
application of render.
2) Before application, dampen the surface with clean water and
allow excess water to drain away.
3) Mix a bag of dry mix powder (20kg) with approx. 5-5.6 L of water
by using an electric mixer.
4) Stir the mixture thoroughly for 5-7 minutes to a creamy paste
without lumps. Then let the mixture stand for 10 minutes for the
additives to dissolve, and then mix again before use.
5) Apply Pinbang Fast Fix by using a notched trowel directly onto
substrate, over which tiling can be achieved within 30 minutes
under normal temperature and humidity condition. Unfavourable
weather conditions such as strong sunshine, low humidity, high wind
speed, or highly water-absorbing substrates will reduce the open
time of tile adhesive.
6) When the surface of tile adhesive is dried, do not use water to
wet the surface. It will form a
very weak and non-adhesive layer.
7) It is recommended to use Pinbang Tile Grout for grouting 4-6
hours after tiling.
(Details of the procedure please refer to our Method Statement.)
Natural air curing for Pinbang Fast Fix is enough.
1. The vertical and smoothness of the substrate must be confirmed
2. The product is suitable for construction in the 5℃~40℃.
3. Don't use the dried paste by reading water.
4. If the base plane is uneven or the back of tile is not smooth,
wiping the paste on the back of brick in order to ensure it full
with paste to avoid hollowing.
Store in cool and dry place, unopened product can be saved for one